StrongVPN Tutorial: Tips to Setup Your Router

Many a time, people are unable to connect to the web because they’re not able to set up their newly purchased VPN service. In most of the cases, the company provides on-site support to help the customers for setting up and using the router in an efficient manner. But in case, the option is not available, then you can read a detailed StrongVPN tutorial on the web to help you setup the amazing VPN services at your location.

What are the Basic Steps Enlisted in StrongVPN Tutorial?

•    Launch a browser

•    Access router settings by typing “http://192.168.1.1” in the address bar

•    Click "VPN Server" on the Advanced Settings menu

•    On the "Enable PPTP Server" item, select "Enable"

•    Select type of Broadcast Support that you would like to proceed with

•    Select type of Force MPPE Encryption from the enlisted mediums

•    Type a range of IP addresses for the VPN clients

•    Type-in your username and password for VPN clients

•    It is important to consider that you can add a maximum of ten usernames and passwords

•    Click “⊕” after entering your username and password

•    Click "Apply" to save settings

•    If you wish to check the WAN IP address, then click ""Network Map"" on the left panel.

•    Click ""Internet Status""

•    Note down WAN IP address listed under Internet Status

Once the router is set up, all you need to do is to configure the same as per your desired settings and requirements. Read the detailed StrongVPN tutorial on the web to configure it for better performance.